Answer / guest

Answer: D

Which command would show all Ethernet interfaces with IPX configured on them? A.) show interface ipx ethernet B.) show ipx interface C.) show ipx interface ethernet D.) show ipx E.) show version F.) show run

1 Answers  

---

Explain how many ways to access router?

0 Answers  

---

Can you explain transport and tunnel mode in detail with datagram packets?

1 Answers   CCIE,

---

Which statement about the data link connection identifier (DLCI) is true? A. It is a number that identifies a local virtual circuit in a Frame Relay network B. It is a signaling standard between the CIDE device and the Frame Relay switch C. It is the clock speed (pod speed) of the connection (local loop) to the Frame Relay Cloud D. It is the Maximum number of uncommitted bits that the Frame Relay switch will attempt to transfer beyond the Committed Information Rate (CIP)

2 Answers  

---

which utility should use to test whether TCP/IP has been initialized on a system.friends plz post the answer with explaination..

3 Answers  

---

Which addresses are INCORRECTLY paired with their class? A. 240 - 255, Class D B. 240 - 255, Class E C. 224 - 239, Class D D. 224 - 239, Class E

2 Answers  

---

What is the purpose of the Data Link?

0 Answers  

---

Which statement is true regarding full duplex? A.) Allows for transmission and receiving of data simultaneously B.) Only works in a multipoint configuration C.) Does not affect the bandwidth D.) Allows for transmission and receiving of data but not at the same time

2 Answers  

---

Which three of the following are true statements about connection-oriented sessions? A.) The segments delivered are acknowledged back to the sender upon their reception B.) Any segments not acknowledged the are retransmitted by the receiver C.) A manageable data flow is maintained in order to avoid congestion, overloading and loss of any data D.) Segments are sequenced back into their proper order upon arrival at their destination

1 Answers  

---

What is the bit length and expression form of a MAC address? A. 24 bits expressed as a decimal number B. 24 bits expressed as a hexadecimal number C. 36 bits expressed as a binary number D. 48 bits expressed as a decimal number E. 48 bits expressed as a hexadecimal number

2 Answers  

---

Which layer defines bit synchronization? A.) Application B.) Network C.) Transport D.) Physical E.) Session F.) Session

1 Answers   Rooman,

---

what is eigrp and what is the benfit of eigrp over igrp what is route summryization if one the router route is not showing the what should be problem how to resolve these problem what is fessible suceer. is the load balncing is one of the property of eigrp what is the metihod of authantication what is the diffrnec betwee pap and chap what is stp command for enabling stp and rstp why switching loop occur what is the main factor of ocuring switch loop what is the mechnaism for stoping the roting loop what is best diffrence betwwen ospf v1 nad ospf v2 what is vtp what is the diffrence between vtp version 1 and veron 2 what is the ip address what is the diffrence betwwen ip address mac address what is dhcp and how it work what is 3 way hand shake what is the difrence betwwen network id and brodcast id what is the network id for 111.111.111.10/29 what is the command for enabling vlan on 3650 csco switch

1 Answers   HCL, Microland,

---