Interested to Buy Any Domain ? << Click Here >> for more details...
What is a characteristic of Store and Forward switches?
A.) They forward the frame before it is completely read.
B.) They work at wire speed.
C.) They are the same a Cut-Through switching.
D.) They read the entire frame and check CRC before forwarding.
E.) They decrease latency.
- 1 Answers
- 17740 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: D
Store and Forward switch will not forward fragments.
The longer the frame, the longer the delay (latency) before
the switch
can forward.
| Is This Answer Correct ? | 11 Yes | 7 No |
Which can be true regarding VLANs? A.) They are created by location B.) They are created by function C.) They are created by department D.) They are created by group
With one method for transmitting frames through a switch, the switch receives the complete frame and checks the frame CRC before forwarding the frame. What is the switch transmission method called? A. CSMA/CD B. Full Duplex C. Cut-Through D. Half-Duplex E. Fragmentation F. Store and Forward
What is the default encapsulation and frame type on an Ethernet interface when enabling Novell? A.) SNAP B.) Ethernet_II C.) 802.2 D.) 802.3 E.) SAP F.) Token_SNAP
You want to enable both arpa and snap encapsulation on one router interface. How do you do this? A. The interface can handle multiple encapsulation types with no extra configuration. B. Assign two network numbers, one for each encapsulation type. C. Enable Novell-ether to run multiple encapsulation types. D. Both arpa and snap are enabled by default so you don't have to configure anything.
What is STP and what is the difference between PVST and RSTP
1. What is an advantage to LAN segmentation? A. Provides multiprotocol support B. Decreases security C. Decreases broadcasts D. Increases broadcasts
What is the syntax of ipv4?
What is raid in ccna?
You want to segment a network. The network is running SNA and Netbios. Which device should NOT be used to segment the network? A.) A store and forward switch. B.) A router. C.) A Catalyst 5000. D.) A cut-through switch. E.) A bridge.
Which protocol used before part of ccna?
What is the default interval for SAP updates? A.) 60 seconds B.) 15 seconds C.) 30 seconds D.) 120 seconds
if i am using active directory,i have router also.then how i configure router,means which address will be default gatway in active directory & roter how to give ip address details in router.
CCNA 
