For Beam steel reinforcement detailing, in the End of the beam do the making of

For Beam steel reinforcement detailing, in the End of the beam do the making of L shape in the rebar is essential in all the cases, specially in the ends of the Beam?

Question Posted / abu786_civil

2 Answers
8622 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

For Beam steel reinforcement detailing, in the End of the beam do the making of L shape in the rebar..

Answer / mdnahid akhtar

it is compulsory to do bend in the end rregion of beam,because the maximum chances of deflection is always near the sopport.in some cases the concrete leaves the rib of steel,called sleepage. so to avoid the sleepage and to increase more tensile strength doing bend (L) is necessary.in cantilever no discussion .but in S.S beam it may run.

Is This Answer Correct ?

12 Yes

0 No

For Beam steel reinforcement detailing, in the End of the beam do the making of L shape in the rebar..

Answer / syed ishaque

At end support beam reactions are fixed beams.. maximum negative moments at support to balance these moments need to provide L and also some time provide extra bars. As per size and length of beams..

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Civil Engineering Interview Questions

what is spt

2 Answers L&T,

What is the difference between chamfer and fillet?

0 Answers

As an engineer, what u should do when the construction of a building doesn't meet the required specifications?

9 Answers

Column is a compression member, concrete is strong in compression..then what is the reason to the column reinforcement..?