Fot testing new star-delta 132 kw motor in electrical
worshop.we should check in star or delta connection as we
do not have higher capacity cable in worshop?
Answers were Sorted based on User's Feedback
Answer / prafull dhuri
I Think we will check motor in star , because in star
connection motor will takes less current
Is This Answer Correct ? | 5 Yes | 0 No |
As you are checking for connection only ,smaller capacity
cable will serve the purpose.
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / suresh
Motor in star connection less current will take ,No need higher capacity cable for trail.
Is This Answer Correct ? | 0 Yes | 0 No |
To check whether connected in star or delta ,just open the
terminal box of the motor .
Is This Answer Correct ? | 0 Yes | 1 No |
How to select busbar?
1.two coupled coils with L1=L2=0.6 H have a coupling coefficient of k=0.8 the turns ratio N1/N2 is......
what is exact meaning of CT core saturation or simply saturation of core.
what is creep of energy meter?
What happens if a three phase induction motor is suddenly single-phased while running? Which type of winding connection will be affected?
22 Answers B4S Solutions, DRDO, FACT, SL Electricals,
why always out of the 3 phase(RYB) of supply, in Y phase w.r.t the voltage is higher? on R & B phase the voltage will be lower as compared to Y phase?
How can we calculate the power factor of an electrical appliance ? Is there any formula ? Is there any meter around to calculate it ? And how to use that meter ? thanks
In power plants the reading changes abruptly to give value (MW -25) (MVAR -15) What are the reasons for this? What is the solution?
what are the problems are there if power factor is leading
line vltage of three phase distribution transformer is 433v and phase voltage is 250v,but we required 230v for domestic distribution,then how we reduce phase voltage of transformer
how to electronic energy metter failed in electomagnectic fild passing in the metter and which thing to defect more on metter.
what are safety measures in /control in diesal engine/ explain them?