Fot testing new star-delta 132 kw motor in electrical
worshop.we should check in star or delta connection as we
do not have higher capacity cable in worshop?
- 4 Answers
- 5309 Views
- Adani, I also Faced
- E-Mail Answers
Answer Posted / prafull dhuri
I Think we will check motor in star , because in star
connection motor will takes less current
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
What is q factor?
How maesure earth neutral value & how much maximum value value required in between earth & neutral.
how to do the ductor test?
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
Mention the methods for starting an induction motor?
when we have to use UPF wattmeter and LPF wattmeter? what is the difference between UPF and LPF wattmeter in terms of construction?
I have a CT meter with ratio 60/5. The meter reading of previous month was 3290.49 and that of current month was 3797.26. How many chargeable units as per normal meter should be my reading.
sir my exam is on 19/6/2013 under electrical branch pls send me sample aptitude questions as well as sample technical questions for jindal steel and power company
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
please send the IS strandard for electrical to sakthi_murugan86@yahoo.co.in
What is the basic rule for block diagram reduction technique?
How each of the following losses occur in d.c machines (i) copper (2)core (3) windage (4)friction please help me
in Telecom DC system-why positive +ve is made earthed.and - ve is fed to load.
how to setting voltage RTCC panel
