what are the steps to commissioning a DCS system?

Question Posted / dhanraj suman

2 Answers
16864 Views
BGR Energy, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what are the steps to commissioning a DCS system?..

Answer / dhanraj suman

1. Panel alignment.
2. Power up DCS with electrical wiring checking.
3. Checking of proper grounding/earthing.
4. Preliminary Electrical I/O testing.
5. Instrumentation Loop checking.

Is This Answer Correct ?

36 Yes

1 No

what are the steps to commissioning a DCS system?..

Answer / aswini ku sahoo

1-proper allignment of pannel
2 power cable laying from UPS DCDB
3-Checking of proper grounding or earthing
4 Negtive terminal of sup. Vol shuold be zero potential.
and then connect the power cable with proper polarity.
5 U r now almost ready to switch on the pannel but now
one imp thing is to disconnect all AI/AO CARD connector
6 All connector pin should not be sort with the ground.
7 Now swith on the pannel
8 Next UTP cable laying work from DPU TO HMI.
9.Agfter proper connection of UTP ping the system
with priper IP addresss.
10 .now start loop cheching and one by one signal throwing
10.Aftr then one by one

Is This Answer Correct ?

2 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

what is the pressure in the tank when its level of liquid is 1.5 meters when its total capacity is 2 meters

2 Answers Engro,

How to decrease opening & closing time of on/off valve?

0 Answers UPL,

what are the different types of terminal lugs used for wiring termination?

5 Answers Yokogawa,

Can we calibrate an actuator?

5 Answers Siemens,

What kind of feedback is used in DP cells.

1 Answers CCIE,

HI, can anybody give details about GAS TREATMENT PLANT CONSTRUCTION,as INSTRUMENTATION ENGINEER what are the responsibilites.what are the instruments mainly instrumentation engineer will deal with

0 Answers GSM, IOCL,

if field commnictor 475 does not communicate with transmitter what will you do ?

4 Answers Samsung,

what are the following documents comes under loopchecking

1 Answers Heisco,

Why we use 250 ohm resistor in series with HART protocol communication?

13 Answers Chemtrols, Instec, Sabic,

Intools training

1 Answers

what is differnace between radar level tranmitter & hart type tranmitter?

3 Answers

what r the different types of instrumentation cables? give their specification?

3 Answers

For more Instrumentation Interview Questions Click Here