Answer / baswaraj

When Synchronous Motor's field winding is 'Over Excited' it
supplies the KVARs back to the the supply lines. This
property is similar to the Capacitor or Condenser.

Answer / amita

WHEN NO MECHANICAL LOAD IS CONNECTED TO THE MOTOR AND MOTOR
IS RUNNING UNDER OVER-EXCITED CONDITION AT THAT TIME IT
ACTS AS SYNCHRONOUS CONDENSER.

Answer / minimanu

When the synchronous motor is running in over excited mode,
it will start delivering reactive current to the electrical
network and shall be acting as a condensor. The synchronus
motor always run on synchronus speed, it can't run above
the synchronus speed. The rective current flow is purely is
function of excitation of the motor.

Answer / niranajn

An over excited synchronous motor operation at no load will
act as a synchronous condenser

Answer / jeetendra kumar verma

The synchronous motor runs under three conditiond under
exited(lagging power factor) normal excited (unity power
factor) and over excited (leading power factor)when
synchronus motor runs with over excited field current it
deliver reactive power to network so in over excited
condition synchronus motor act as a synchronus condensor

Answer / amit

Synchronous motor gets over exited, and runs above the
synchronous speed then it draw the leadding current so in
this time it behave as a synchronous condenser.

Answer / harry

synchronous motor runs under over excited it would draw
leading current as capacitor

Answer / pandi

in synchronus motor field winding is over excited (Eb>V).now
motor supply the reactive power(KVAR)&draw current at
leading power factor.that conditions called as synchronus
condenser

Answer / rajeev ranjan

A syncronous motor can act as a Syncronous Condensor when
and only two Basic conditions fulfill
1.Motor should run at No load operation and
2.Field Winding should be Over excited
With these condition motor start giving the reactive
current to the supply system.

Anybody now how to claculate the Bescom power consumption?

1 Answers  

Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing

0 Answers  

why there is a high voltage line in multiplication of 11?i.e.- -66kv,11,kv,22kv

4 Answers   Bhel,

how to save the power?

2 Answers  

the resstance of a thermistor is 5000 ohm at 25degreeC and coefficient is .04/degCel. A measurement with lead resitance of 10 ohm will cause an error of

1 Answers   GATE,

i want wipro vlsi placement pattern please send me

0 Answers  

in india why 50 hz and 220 volt taken as standard rating for equipments whereas in US 100hz and 110v is consided as standard rating.is this method save power.

5 Answers   Wipro,

What is meant by RVT and NDR ? expansion and details of it

0 Answers  

Why the wave trap is put in Y phse only in switchyard?why not in other phases?

1 Answers   IAG Automation, REL,

in which material resister are made?

1 Answers  

100V supply is appllied between 500K Resistance bulb. for 1 kwh energy, how long time the bulb will glow? explain the calculating method.

3 Answers   Bhel,

low voltage grounding is done by?? 1)solidly gnd 2)ressistance 3)reactance

1 Answers