What are the Design Mix proportion,and where they are used
Answers were Sorted based on User's Feedback
Answer / arjun
Design Mix Proportion includes cement, sand, aggregate,
water and admixtures for getting high compressive strength
of concrete with suitable proportions. generally in
different locations the properties of these materials is
different so aviod the genaralproportion like 1:2:4 or
1:1.5:3 various samples are taken randomly upto getting
good results mix design can be done.
design mix normally used in all works like Mass Concreting,
Concrete PAvements & Bridges, Dams, Flyovers and huge
structures
| Is This Answer Correct ? | 4 Yes | 0 No |
Answer / santosh singh
design mix is done to achieve higher strength of cement ie
over m25 grade.they are used for dams, skyscrapers,mass
construction etc
| Is This Answer Correct ? | 3 Yes | 3 No |
Answer / rajesh bhowmick
For Design Mix there is no proportion. Volume mix does. We have to calculate the weight of the cement, fine and coarse aggregate to achieve the target strength.
| Is This Answer Correct ? | 0 Yes | 0 No |
Design mix proportion is the proportion of concrete ingredients i.e. cement, sand,aggregate and water which is designed by trying different combinations of ingredients so as to achieve higher strength with economical design.
| Is This Answer Correct ? | 0 Yes | 0 No |
How to do base isolation using ETABS software?
in built up area basis what is ratio of concrete & steel ratio may be consider in per sqft quantity
logical reasoning
Water filter calculation formula
how many kilograme per metre run of 6mm diameter steel bar
a)If column dimensions are 250*400mm , what will be cutting length for 8mm stirrups and how to calculate it? b) If beam dimensions are 200*400mm , beam coveris 25mm , slab cover is 20mm , what will be the cutting length for stirrups? c)Column dimensions are 250*400mm , reinf. is 12nos. bar of 16mm dia , stirrups provided are two legged, what will be the length of each ring? Regards
27 Answers Alfaraa, Speco, Supertech, Welspun,
what is the MSL?where is it located?
2 Answers C-Tech RC Design, Era Infra Engineering, IVRCL,
Why we are using 150 mm X 150 mm X 150 mm cubes for testing the compressive strength of concrete in CTM and why not other sizes?
the capacity of water tank in liters if the diameter is 3m, and maximum height of water level as 1m.
what is difference between GTS bench mark and temporary bench mark
what is the difference between composition of ceramic & glazed tiles?
how to calculate the quantity of steel used for construction..
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)