Answer / chirag

Simplest method to check out your earthing is that: Take
one lamp.connect one terminal of lamp to phase and other to
earthig pin. Then switch on. If lamp is on then your
earthig is o.k.And if lamp dark then you need to earth your
socket.

We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks

0 Answers  

---

why are you use the crgo core lamination in transformer

6 Answers  

---

why we ground the scondary of current transformer.

4 Answers  

---

What is superposition theorem?

0 Answers  

---

How to take Transformer oil Break down voltage test?

9 Answers  

---

What will be the average KVA rating of Auto Transformer for 75kw 415V , 3phase induction motor

2 Answers  

---

would the same effect be achieved by reversing the connection to one winding of the induction motor 3-phase?

0 Answers  

---

Difference between ELCB and RCCB?

5 Answers  

---

What is the difference between electronic regulator and ordinary electrical rheostat regulator for fans?

0 Answers  

---

I have 800 Amps MG Fix type breaker It is in on line & it has been given only UV (under voltage)coil connection for tripping purpose.now it is not working properly means its getting tripp so how can i replace it or how can i rectify the problem without destrubing my load??????????

2 Answers  

---

If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.

0 Answers  

---

what r the tests on the 3 phase transformers can any one explain how to test using megger on transformers thx

2 Answers  

---