why we ground the scondary of current transformer.
Answers were Sorted based on User's Feedback
Answer / k.prakashchandra
To remove the influence of high voltage of the primary due
to capacitance.
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / nidhi thakkar
In ct very large current passes always. if it is not ground
then it will damage the ckt.
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / selvakumar.k
In crt high current occurs,so we neutralize the ground
Is This Answer Correct ? | 0 Yes | 0 No |
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
why dc supply given to ac alternator rotor
Graphs of measuring power and speed on dc motor
What is meant by sotf,lbb,power swing,pole discrepency,auto reclose?
1 Answers Bunge, Electrical, Omega, TCS, TNEB Tamil Nadu Electricity Board,
why we use to always generate power below 16kv.why not at higher voltage?
What are the application of Under voltage release?
2 Answers Techno Electric and Engineering,
Why air gap in rotating machines should be small?
what is the physical connection of a analog i/p to a analog i/p module (ab plc)and through a analog o/p module(ab plc) to a analog o/p . and how all the process control by scada
what will happen if the bus PT fuses are accidently removed from the circuit in 6.6kV feeder?
what is the disadvantages of common earthing for AC and DC equipment? (i am talking about inverter control room and inverter duty transformer earthing is common...?)
what is the potential difference between line and earth?
Why OLTC(On Load Tap Changing)transformer is not recomended for improving voltage instability?