my question is that....few days ago i had installed a three phase motor starter for an electric saw.the motor will run and make the hydraulic pressure which will be goes to pressure cylender by up and down lever.two number of limitswitches are also installed on cylinder for safety of motor.now when the arm of cylinder reaches to the upper or lower limit it will cut the motor's line.and motor will be stop.now wana know that what will i do that motor runs continue after the limitswitch cut it down but it shold not be made any pressure.pls answer me in brief.

3 Answers  

---

Why the rotor winding is short circuited of induction motor

1 Answers  

---

Tell me about Tesla.

1 Answers   Tata Power,

---

what will happen if secondary of potential transformer (220kv/110volt) of any metering core or protection core (cables) of any phase got earthed??

1 Answers  

---

difference between servo motor and synchronous motor

0 Answers   Hitachi,

---

Is there any problem about which the drive (inverter) doesn't show/display the alarm and/or fault but instead of this , it doesn't work ? I want to know that could there be any kind of problem in the drive when the drive doesn't display the alarm and/or fault ?

0 Answers   Siemens,

---

how calculate gd2 of ht motors

0 Answers   Hindustan Copper Limited,

---

What is ht lt switchgear.

3 Answers   Bhel, HBL Power Systems,

---

what is the purpose of fuse?

7 Answers  

---

What should be the minimum and maximum ohmic value for earthing?

2 Answers  

---

what is transformer?

2 Answers  

---

How we calculate the current carrying capacity of H.T. cabel?

0 Answers   Bhel,

---