Answer / nishant2110

Noise in transformr is caused by MAGNETOSTRICTION.

magnetostriction is process of slight changing physical size
of magnetic material when kept in varying magnetic field.

Since gap due to bad insulation and bad stacking factor give
sufficient place for core to vibrate in between due to
change in its size

how to give earthing in plain?

0 Answers  

---

my project load is 6 MW so please suggest the size of cable.. ALU 3c 400 aqmm cable can be sufficient.. is there any thumb rule for calculation of cable size please help me

1 Answers  

---

1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.

0 Answers  

---

what is the CT of protection and CT of metering ? what is class 5P10 & 5P20 and class PS ?

16 Answers   JEE Main, ONGC, VRA,

---

why rotor winding in induction motor is not earthed. normally we uses star winding in rotor .why?

3 Answers   Anglo Platinum, TATA,

---

howmany types of compresor is there? and how to calculate compresor capacity?

3 Answers  

---

In a synchronous motor. if start is running at high speed.  What will be the starting torque : Higher Lower Zero

0 Answers  

---

in an ac series circuit there are 30 bulbs are connected in a serial set.what will happen if one bulb is fused and we removed the bulb and reconnect with the remaining bulbs? (29 bulbs). will the brightness of other bulbs increase or not?

3 Answers  

---

what is the effect of power factor in electrical circuit ? if we mainten power factor near about unity (0.999) our energy consumption Units increase or decrease?

11 Answers   Piramal Healthcare,

---

Why we use two wattmeter during block rotor test and no load test of 3phase induction motor? And how can we understand the neat power requirement of from this test?

2 Answers  

---

what is transformer

5 Answers   Aegis,

---

What are the advantages and disadvantages of oil filled transformers?

2 Answers   Mercantile Marine Department, Studio College,

---