why dont we use the same pylon to carry 400 kv plus 220kv
and 33 kv ?
Answers were Sorted based on User's Feedback
Answer / guest
this is because each line have their destinations,and at
same point other lines are forced to be either stepped up or
down
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / k.prakashchandra
400 KV line is very important and should not be disturbed by
any other lines.Further, the lines are DC and double strung
,hence the structure of the pylon is such that it can not
accommodate any extra line.
Is This Answer Correct ? | 0 Yes | 2 No |
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
What is the function of NER and NET?
0 Answers Asian Paints, GHH RAND,
how much winding resistance of 0.75kw to 12.5kw 3ph sqwiralcage induction motor?
what is the necessity of under ground cables ??
how can we know cable size for a given current? if any one have catalogue plz mail to vijay_raju369@yahoo.co.in
what is the meaning of the parameters labeled on the surge arrestor like 150/20 ???
can any one tell in easy method for circulating current ??
what will happen at secondary side of transformer if i increase voltage at primary side?while V1*I1=V2*I2 will secondary voltage or current increase?
110 KW MOTER DOL STATER 240SQ.MM CABLE MOTER AND STARTER DISTANCE IS 110 METER WHAT IS VOTAGE IN MOTER END AND SYSTEM VOTAGE IS 415 V HOW I CAN CALCULTE
What is the differance between 2 dc motors of armature voltage 660 v and 440 v?
Will sag depends on the Specific Resistance of the conductor?if not Why??????????
can we use HPSV LAMP in HPMV LAMP fixture ?and viseversa.