Interested to Buy Any Domain ? << Click Here >> for more details...
why dont we use the same pylon to carry 400 kv plus 220kv
and 33 kv ?
- 2 Answers
- 5395 Views
- Focus, Focus Energy, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
400 KV line is very important and should not be disturbed by
any other lines.Further, the lines are DC and double strung
,hence the structure of the pylon is such that it can not
accommodate any extra line.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
How to calculate fault level of 11 KV system
What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
what is the main function of capacitors in mccs.
any earth foult trip the relay but in welding time not trip by earth foult
How many double suspension hardware fittings are required on a double circuit transmission tower?
how to setting voltage RTCC panel
what is the difference between rectifier and converter and commudator?
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
What are the different sign conventions used in electric circuits?
While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?
sir my exam is on 19/6/2013 under electrical branch pls send me sample aptitude questions as well as sample technical questions for jindal steel and power company
why 3 phase is converted into 2 phase using electronics circuit why not 2 phases are diresctly putted from the 3 phase transformer??
How to calculate the sag of OPGW during stringing???
why we setting 95 deg and 105 deg in wti and oti of distibution transformer ? give the reson for that ?
