Answer / banda saivarun

it is a Vector group of transformer
Vector group means it defines the primary & secondary side connection type. It says D for the delta connections (windings connected between two phases) & Y for the star connections (windings connected from each phase to ground). The 11 stands for the phase displacement of the secondary referenced to the primary. Imagine a clock with only an hour hand; at 11 o'clock, the hand is at 30 degrees to the reference (12 c'clock), so the secondary is at 30 degrees to the primary. tor group of transformer

Answer / nikhil karle

this is vector group of xmer
Which is stand as
D delta(primary)
Yn star with neutral (secondary )
11 30°lead

Answer / k.prakashchandra

It should be Dyn11

Answer / mageshwaran

it denotes the connection of primary & secondary winding of transformer, in which primary is delta connection and secondary is star connection with 30 degree phase displacement

Answer / banda saivarun

dny11 is of trnsformervector group

How will A Medium voltage circuit breaker(11 kV voltage level) operate under short circuit fault condition whether It is having short circuit release like Low voltage circuit breaker or relay should be given?

0 Answers  

how calculate gd2 of ht motors

0 Answers   Hindustan Copper Limited,

what is the reason for earthing static equipments? why?

3 Answers  

what is voltage rise and voltage drop?

8 Answers   HP, jetking, TCS,

Tell the details of the precommissioning tests that are performed on distribution transformer, power cable and switchgear (11kv).

1 Answers   Reliance,

what is ALF and ISF in current transformer?

1 Answers  

why restricted earth fault protection can not operate for phase faults??as there will be a current in secondary of ct,when a phase fault occurs!

1 Answers   GMR,

What is a circuit breaker contact multiplier relay?

2 Answers  

what is the difference between earth and unearth cable?

1 Answers   Essar,

what is load which is indicated in power plant generation panel? in any power plant

1 Answers  

Hello, im taking an introduction to PLC..and i'm having a hard time on creating a program for 2 lamps blinking alternately with this button characteristics: 1.) One push button (starts upon pressing) 2.) Same push button (when pressed again, will pause the system) 3.) Same push button (when pressed again, will continue the paused system) 4.) Same push button (when pressed within 2 seconds, will shut off the system) Pls..i know this is just a simple problem for you guys..

2 Answers  

what are the different sizes of U.G. cable & where these cabl;es are used according to voltage ..

0 Answers   HPCL,