why power generated only 11KV not more than????????
and why power up/down is multification of 11*?=??.???
foe Example 11/33,11/66,66/11KV etc,
Answers were Sorted based on User's Feedback
Answer / lakshmi
power is generated at11kv and multiples of 11 bcz of form
factor i.e., for sinusoidal is 1.11.
| Is This Answer Correct ? | 12 Yes | 2 No |
Answer / vijayakrishnan
may be increased greater than 11kv insulation of winding also increased & maintenance also tough.
step up transformer used for reduced cost of conductor
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / subbu
normally the genaration station genarates only 6.6kv it is
step up and sen to near substation then we r using
6.6kv/11kv it for avoiding lossesi.e eddy current.then we
step up/down as per load on the feeder
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / amardeep sah
Reduce losses eddy current and hystersis and tough maintanance and so 11kv used for sted up and step down in transmission line
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / yash sharma
remember it - "higher voltage is beneficial for transmission not for The generation"
sine wave has form factor of 1.11
so 1.11*10000=11 kv
1.11*20000=22 kv and so on
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / thingujam
1) 11kv is a reliable and conventional generating voltage.
2) Multiple of 11KV is a conventional multiplying factor
| Is This Answer Correct ? | 1 Yes | 2 No |
Answer / dkverma67
AS insulation of alternator winding is comparatively easy & economical at 11KV.
Voltage rating is always multiple of 1.1 or 11 due to form factor. EMF induced in alternator is E(max.) value. The average value of induced EMF =Emaximum x 1.11.Here 1.11 is farm factor.
| Is This Answer Correct ? | 1 Yes | 2 No |
what is diffrential relay used in generator plz give brief explanation
why fault current always calculated for 1 seconds?
Give me the calculation steps to design an electromagnet to be work in 230V 50 Hz AC Supply. Also give force that is created by that electromagnet when it gets energized.
Describe how a salient pole / projecting pole rotor differs from a cylindrical rotor and state the application of each rotor respectively
please send the IS strandard for electrical to sakthi_murugan86@yahoo.co.in
Can we use generator transformer as step down transformer? How?
please give some hindalco placement papers for written exam
what is draiv work
Residual voltage & residual current used in which protection?
5 Answers Qatar Gas, Reliance, Transformers and Electricals,
what is the difference between star connected and delta connected motors
What are safety device in vcb and acb?
0 Answers IOCL, L Usine Fashion,
why the making current is more than then the breaking current and if its true then its about a controling circuit or breaker power contact points
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)