What shall be minimum thickness of firewall in between two
transformers and which code specifies it ?
- 1 Answers
- 18454 Views
- I also Faced
- E-Mail Answers
Firewalls between transformer (Firewall) shall be provided with 230mm thick RCC or 355mm thick brick wall.
You can refer NFPA 850 for reference.
| Is This Answer Correct ? | 9 Yes | 1 No |
How efficiency of thermal plant can be improved?
why we are maintain phase to phase clearence
I have a 3 phase 600 volt prim. feed and a 120/208 sec. Isolateing tranformer .We are using this system for safety against shock . What is the proper grounding ?? Does the common on sec. get earth ground ???
What is knee point voltage of transformer?
What is warm / cold start of HT motors. How many warm start & cold start are possible in a day?
why -48 volts dc used in telecommucation
star delta starter control wiring diagram?
Define damping ratio.
I have recently seen a transformer which had two primary terminals and was connected between two lines,i would like to know what kind of transformer is it?short discription about it,any advantages,purpose of usage of the same.............
why the value of impedence is taken as %impedence in fault currrent calculation
why we use salt for earthing?
Which protection detects both AC and DC?
-
Civil Engineering (5085) - Mechanical Engineering (4451)
- Electrical Engineering (16632)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
