Answer / guru

The motor will get low current rate and much voltage,so the efficient of machine is poor and low power factor.

Answer / hemant

normaly in star connection motor take very less current as
compare to delta connected. because of current get root 3
times less than phase current. in fact motor almost take
low current but low power factor also. you must know how
much load give to motor if motor load is hgh and its
connected star then it unable share load whether it requre
to delta.

Answer / sheikh

In star connection motor taking excessive current as compare to delta connection.

Answer / ali

Normally we have observed in several times that, when we switched on the any star delta motor than momentary time of star connection motor gets high current and current going to down when motor was shifted in delta

Answer / vetrivel

long time working in delta connection

how to calculate the earthing conductor & no. of earth pits required

3 Answers  

Can step down transformer works as step up one???

2 Answers  

what is the function of turbo in dg sets

1 Answers  

Why sometime AVR and sometime Booster coil is used in Alternator? what is the diferance between AVR & Booster coil due to which they are selected

0 Answers   Bajaj,

CAN 50Hz transformer work at 60 Hz power supply? if yes how it is possible?

2 Answers  

what is the function of RMU?

4 Answers  

define the active power?

0 Answers  

What is electrical cable termination

0 Answers   Gulf,

In Ferranti effect,Receiving end voltage is greater than sending voltage,why? can anybody tell me the answer

15 Answers   Engineers India Limited,

what is the range of thermal overload and over current. Answer should be in percentage of current.

0 Answers   RMSI,

why buchholz relay installed in inclined position

3 Answers   Eskom,

What is LOP Sensor in DG??????

7 Answers   Emerson,