stub column means

Answers were Sorted based on User's Feedback



stub column means..

Answer / modipraveen

Stub column is one which does not hav footing & Pedestal
support(Reinforcement), which is rises from Beams or Slabs
for upper levels... and also know as floating Columns

Is This Answer Correct ?    41 Yes 5 No

stub column means..

Answer / ajay kumar singh(jrc)

jaise kisi ped ke mote tane se koi shakha nikalta hai use
stub ped kahate hain,usi tarah kisi stucture me kisi beam
se koi column nikalta hai use stub column kahte hain.

Is This Answer Correct ?    24 Yes 1 No

stub column means..

Answer / manikanta73

known as floating columns which rests on beams that doesnt have foundation

Is This Answer Correct ?    14 Yes 1 No

stub column means..

Answer / jitender kumar mishra

stub column is start the roof salb or beam

Is This Answer Correct ?    17 Yes 8 No

stub column means..

Answer / dhanasekaran

Its rest below the ground level and combined with footing

Is This Answer Correct ?    1 Yes 0 No

Post New Answer

More Civil Engineering Interview Questions

Define graphics window?

0 Answers  


What is stripping?

2 Answers  


how do we calculate the quantity cement,sand, & aggregate for M20,M15 for 10cum.

7 Answers   Opera, Raheja, Star,


How much percentage of silt contain maximum allowed?

5 Answers   ACC,


how much aggregate need for 1:4:8 p.c.c in 1sqm area?

5 Answers  






Why the statue of liberty is made of copper?

0 Answers  


Given a selection of 28 day cube test results for concrete placed of design mix C 35 and not all of which are greater then 35 MPa, how does one decide if the concrete in place is satisfactory. Are there a minimum number of cubes that need to be tested to decide that?

2 Answers   RPS,


Why steel rods are produced only in even dimensions?

0 Answers   Billimoria,


Slow setting admixture is used in mass concrete because of – –

4 Answers   Reliance,


which has high coefficient of discharge venturimeter or orificemeter

1 Answers  


How much quantity of cement and sand required for the inlining of 610mm dia MS pipe 8.7mm thk.Inlining thickness is 10mm and CM ratio is 1:1.5.

0 Answers   IVRCL,


rate analysis,what is PERT, TMT ,UPVC

1 Answers   BPTP,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)