Answer / mohammed emaaduddin

I donno the exact number of methods of temperature
measurement. But the different measuring devices for
temperature measurement are,
Thermometers, Pyrometers, Resistance Temperature
Detectors(RTD), Thermistors, Thermocouples and Thermowells

Answer / sudhansu

temperature can be measured my basically two ways...
a)by direct contact method in which we
have-rtds,tc,thermometers etc. where we have to make direct
contact of transducer with the mesurend.
& b)non contact type like pyrometer

Answer / sandip patel

same with the addition bimettalic strip is also one of the measuring device for the temperature

Answer / imam

rtd.tc .termistor

Answer / abbas

1.mechanical methods(expansion of materials,pyrometers)
2.electrical methods( rtd,tc,thermistors)

Answer / abhay raj

exactly the same answer as stated in ans. no- 4.

non contact method used to measure temperature is- RADIATION
PYROMETER

HOW THE ORIFICE & PRV SIZING BE HAPPENED -- EXPLAIN IN BRIEF

3 Answers  

When a timer is placed in RS Logix 5000 with preset value less than its scan time it is malfunctioning. i.e., if the preset is set to 30ms still the timer TT bit is counting till 150ms(its scan time). Any solution for the problem?

2 Answers   Balco,

Full form of KKS when use DCS.

0 Answers  

i have level transmitter -400 to 0 range for steam drum application but i am unable to calibrate if installation of lt below lower tap what will be the effect ? and as per std wht is location of lt ,above lower tapping or below

1 Answers  

What is DeltaV?

2 Answers  

Give 2 application of quartz crystal used for process parameter measurement.

0 Answers   ADMA OPCO,

what does 5/2 solinoid valve means?

5 Answers   UltraTech,

Why hunting will occour in control valve?

6 Answers  

how to control motor load with rpm or vfd

1 Answers  

how can calibrate pressure transmeeter in the feild ?

1 Answers  

what is air to open and air to close control valve and difference btwn this...and how to measure milli amp by this...and what is the role of positioner and i/p converter in this..plz help me

2 Answers   HCL, SOC,

If the vibration probe near to the shaft,then output voltage will be decreased r increased?How?

1 Answers   Amtek, Hamsco, IJT,