Answer / symon lourdes

In other way...

Open Loop means ,only we use for the monitoring and
recording purposes

The closed loop will be for the controlling the final
control element in order to match with the desired set
point.

Answer / debasish sarkar

Open Loop: If we don't have any control in O/P of a loop
that is called open loop.

Close Loop: If we have any control in O/P of a loop that is
called closed loop.

Answer / naveen pandey

LET's elaborate in right way !

IN closed loop system, a feedback is provided so that output can be compared with the reference value to give an error signal. by this one can control the parameters of a system and output value can be optimized.

Whereas in OPEN LOOP, no feedback is provided. optimization is not possible.

Answer / raj mon

open loop which having only indication process variables is open loop
close loop both indication and controlling process variables is close loop

Answer / guest

There are seprete controller for all system in open loop
i.e gas flow, compressed air ect.and in close loop
controlled by one computer.

What is zener diode? What is voltage regulator?

0 Answers  

In close vessel/ drum why we use d.p. transmitter of -ve range i.e. (-)500 to 0 mmwc.

2 Answers   IMECO, Voltech,

What is difference between magnetic flow transmitter & Electromagnetic flow transmitter?

1 Answers  

what are different types of cables used in instrumention how to calibrate a level transmitter online ( rosemount )

1 Answers  

what is purpose of three way manifold valve using for dp transmitter

1 Answers  

how will do square root transmitter calibration

2 Answers   Roche,

Why is the orifice tab provided?

0 Answers  

how to do loop checking pls email to shanavaska2000@yahoo.com

2 Answers   Kentz,

You are looking at the RS-485-side of an RS-232/RS-485 converter and the power supply voltage for the converter is +5V. Under idle conditions (no transmission), and assuming you have enabled the RS-485 output: what would you expect at: (a) Output A measured against output B (b) Output A measured against ground (c) Output B measured against ground

1 Answers   EIT,

Why three wire is using with a RTD?

3 Answers   ABB, MAHINDRA,

Where are oxygen analysers installed in cfbc boilers? What are their usual readings?

0 Answers  

if we have 380 KVA DG. how to calculate Power Factor. With detailed formula

1 Answers