Answer / subash m k

Every rectangle is a parallelogram but all parallelograms
are not rectangles.

Answer / sivalingam

Rectangle - all angles are equal (90')
parallelogram - two adjacent angles are equal.

Answer / busireddyravi

In rectangle all the corners are must be angle of 90 degree
and opposite sides and diagonals (Diagonal are mutually
perpendicular to each other) are equal in length , where
as in parrellelogram face to face sides are parallel to each
other and diagonal are not eaqula (not perpendicular to
each other)but it not necessory to meet in right angles at
corners.

Answer / guest

rectangle make angle of 90 degree at all its corners, where
as in parrellelogram face to face sides are parallel to each
other but it not necessory to meet in right angles at corners

Answer / jose venturina

The difference is the interior angles. The interior angles
on rectangle are all the same whereas for parallelogram,
only opposite interior angles are the same.

Answer / busireddyravi

In rectangle all the corners are must be angle of 90 degree
and opposite sides and diagonals (Diagonal are mutually
perpendicular to each other) are equal in length , where
as in parallelogram face to face sides are parallel to each
other and diagonal are not equal (not perpendicular to
each other)but it not necessary to meet in right angles at
corners.

Answer / navya

diagnonls are equal in rectangle.
diagnols are not equal in parallelogram

Answer / guest

rectangle is staraight corner & Parallelogram is slightly
crossed corners

Answer / daniela scerbina

A rectangle IS a parallelogram but it has a special case;the adjacent angles are equal.A parallelogram is slightly slanted unlike a rectangle. The same case is with a square.HOPE U ENJOYED THIS EXPLANATION.HOPE IT HLEPED;THANKS....... :D :D :D :D :D

Answer / phaneendra

Rectangle & parallelogram is plane figure with four
straight sides but rectangle has four right angles& unequal
adjacent sides.In paralleogram opposite sides are equal.

TELL ME THE EQUATION FOR OGEE SPILLWAY

0 Answers   TCE,

1)How to calculate concrete cube testing load by area in mpa 2) in kg/cme also

1 Answers   SLEC,

what is the difference between factor of safety and partial safety factor.??

2 Answers   KJH, NTPC,

crank types

0 Answers   MNC, RBDC,

for plaster what is the suitable sand.

3 Answers  

is there zone 6 for earthquake in india? on what basis the naming of the zones are done in variuos countries?

2 Answers  

what is difference between long column and short column?

16 Answers   L&T, Tomi Polytechnic,

tmt steel

2 Answers  

why we provide plastic sheet under lean concrete/pcc.?

2 Answers  

concrete strenght is increased if using sisal fibre in concrete?

1 Answers  

what if i want to lap a 20mm dia and a 16mm dia together wat will be the lap length?? a) 1m b) 80mm

5 Answers  

what is local scouring?

2 Answers