what is the electricity
Answers were Sorted based on User's Feedback
Answer / gopal manda
Electricity is a form of energy. Electricity is the flow of
electrons. All matter is made up of atoms, and an atom has
a center, called a nucleus. The nucleus contains positively
charged particles called protons and uncharged particles
called neutrons. The nucleus of an atom is surrounded by
negatively charged particles called electrons. The negative
charge of an electron is equal to the positive charge of a
proton, and the number of electrons in an atom is usually
equal to the number of protons. When the balancing force
between protons and electrons is upset by an outside force,
an atom may gain or lose an electron. When electrons
are "lost" from an atom, the free movement of these
electrons constitutes an electric current.
Is This Answer Correct ? | 9 Yes | 2 No |
A 3 phase motor, 440 voltage, induction motor. If we take out rotor from motor and if we give supply 440 volt to stator then what happens?????
hi there i am highly enthusiastic about discussing electrical concepts , and hence i wud lyk to invit al do intrested to join me at gtalk and hav a dscussun of the concepts , ad me as a freind . my email id is rakesh.2k99@gmail.com
Excat meaning of burden in only one word?
3 Answers Bhel, DG Electricals,
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
what is the current density of copper & alluminium.
what is the difference between switch yard to residential area.and how much required it.
Why oil preferred over the air as a cooling medium for high rated transformer?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
What are the operation carried out in thermal power station?
Which test will be more severe for VCB?
Any one can explaination about calibration with rotating sub standards?
when will cause the negative sequence falut in electrical system?