IN a transformer during power supply how the LV and HV
bushing works??
Answer Posted / hussaini
Bushings is just used to give
proper insulation to the
income and out going wires
of transformer ..
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
how can we select the type of wire.what factors we have to look on it , do we have some formula to calculate it. please guide me on it
all details of DG UPS HVAC
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
TYPE'S OF BREKAR ,WHAT IS TRANSFORMAR & SAFTY. STARTER DOL & STAR DELTA STARTER.
Why is the frequency not changed during transformation of electrical energy in a transformer?
Incoming line 11kv And transformer capacity is 2500kva. Consumption load is 1300A. Then fuse capacity is 11kv line.
If a current -8+6sin6t is flowing three ammeter, one is a centre zero PMMC meter, one is true rms meter and one is moving iron meter. What are the reading of these three meter respectively?
In a large office how do we calculate required number of light fittings, assuming fittings are 4x18W or 2x36W fluorescent fitting ?
What is the function of the circuit breaker failure relay?
why in an industry; machine having rated 200 h.p stopped after power factor is maintained above 0.97 lag by control panel in view-of energy saving
why the projects getting loss?
In ht capacitor ckt we are using LBS Panel it having isolator with fuse, one of HT fuse flash over, so what is reason behind this event.
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.