How can we calculate single phase load into three phase load

Question Posted / arasu

2 Answers
5473 Views
Jindal, Tanfac, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

How can we calculate single phase load into three phase load..

Answer / pradhyumn

By checking the phase with respect to ground with
multimeter or with a test lamp.

Is This Answer Correct ?

3 Yes

1 No

How can we calculate single phase load into three phase load..

Answer / tula.srinivas

we can calculate by converting it by 1.732 factor, that
means multiply the single phase load with 1.732 and you
will get the equivalent 3phase load valur.

or
3 single phase units is equal to one 3phase load

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

What is the basic difference between AVR and stabilizer?

2 Answers Gujarat Alkalies and Chemicals GACL,

In Panels Main Incomer considered should be TPN or FP?

2 Answers

Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?

0 Answers

HOW can i REuse the fused MLL LAMPS & GLS LAMPS at our factory

0 Answers

Dear, How much ph is maintained of water electrolite used in lrs for slipring induction motor ?

1 Answers

WHAT IS THE REASON FOR LOW VOLTAGE IN HOUSES?*

1 Answers

How do we measure earth fault current in Generator Transformer(20/420kv),Station Transformer(20/11 kv) and Unit Transformers(20/11kv) for our plant system, since these don't have any Neutral earth Fault relay connected to their Neutral Earth? But for Unit Service transformers(11/.433 Kv) we have an Earth Fault Relay connected to its neutral earth.Why is such so?

1 Answers NTPC,

I have two power supply.a)govt. power b)Captive power.3 phase load connected inside factory.when source change govt. source to captive some motor rotate reverse. Is phase sequence changes when if off & on?If I off generator & on it again is it possible to get changed phase sequence??

4 Answers ABB,

what is the resultant phase shift in a 3 phase power system including neutral if on or more phases gets grounded or short circuited. kindly explain in detail for the reasons...

1 Answers Enercon,

why control circuit voltage always chooses to be 110v and 220v? and in where it is 110v and 220v? and in where it AC and DC?

2 Answers

what is OLTC and difference between RTCC and OLTC

7 Answers Sodexo,

what is different between phase and netural

0 Answers

For more Electrical Engineering Interview Questions Click Here