How can we calculate single phase load into three phase load
- 2 Answers
- 4550 Views
- Jindal, Tanfac, I also Faced
- E-Mail Answers
Answer Posted / pradhyumn
By checking the phase with respect to ground with
multimeter or with a test lamp.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2
What Is HO factor in power selection
How earthing/grounding done in aeroplanes and ships.
How to calculate the volumetric capacity of a oxygen & Nitrogen gas Cylinder if pressure is 145 kg/cm2 & water capacity of cylinder is 67 liters.
On what basis the the size of Lightning arrester for buildings are selected ?
WHTA IS LIMT OF LEAKGE CURRENT OF 11 KV 1 CORE 1000SQ.MM. XLPE CABLE.LOAD ON CABLE IS AROUND 600AMP .LENGTH 500 MTRS.
The D.C. spark test is applicable to single conductor cable & assemblies of insulated single conductor cables without insulation shield,metallic sheath or metalic armor?
While testing a ZCT what parameters have to check or measure?
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
Hi everyone. Some Generators uses 3-Pole breakers with extra contactors for Neutral. Some uses 4-Pole. Why so? What is the idea behind this? Thanks in advance for the solution. Kr.
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
what are the breakdown voltage rating of mini- curcuit'transfarmer!
Importance of fault current in power transformers and how to monitor the same? How is it different from winding temperature?
give me atleast four differences between circuit and network
how to find ratio of CT & PT in 66/11kv 12 mva supply system ? explain with calculation.
