Golgappa.net | Golgappa.org | BagIndia.net | BodyIndia.Com | CabIndia.net | CarsBikes.net | CarsBikes.org | CashIndia.net | ConsumerIndia.net | CookingIndia.net | DataIndia.net | DealIndia.net | EmailIndia.net | FirstTablet.com | FirstTourist.com | ForsaleIndia.net | IndiaBody.Com | IndiaCab.net | IndiaCash.net | IndiaModel.net | KidForum.net | OfficeIndia.net | PaysIndia.com | RestaurantIndia.net | RestaurantsIndia.net | SaleForum.net | SellForum.net | SoldIndia.com | StarIndia.net | TomatoCab.com | TomatoCabs.com | TownIndia.com
Interested to Buy Any Domain ? << Click Here >> for more details...


What phase difference between p and s
winding of transformer



What phase difference between p and s winding of transformer..

Answer / rehmat

the phase difference between the P & S of the transformer is 180 degree.

Is This Answer Correct ?    23 Yes 1 No

Post New Answer

More Electrical Engineering Interview Questions

If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????

0 Answers  


When a square wave is applied to primary of a transformer then what will be output wave form of secondary ?

0 Answers  


What is current & voltage ? Voltage perform at any load without current or not?

0 Answers  


A cable with concentric PE conductor must be used with frequency converter circuits what does its means.?

0 Answers  


What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket

0 Answers  


what is dielectric heating

1 Answers  


WHAT IS THE DIFFERENCE BETWEEN GENERAL INVERTER AND SOLOR INVERTER TELL ME PLZ

0 Answers   Epcon,


In DC motor,the field MMF is given by NI.N-no.of field winding turns,I-excitation and both are constant.Then how could the main flux decreases due to armature reaction.

4 Answers   Bhel, IBM,


What is the full form of PSD & CSD ?

6 Answers   NIFT, PNG Power, PSD,


what is meant by slip & where its occur ?

5 Answers   Lanco,


PLease anyone can tell me CTUM-15 specification?

1 Answers   Gilbert Maxwell,


what effect on electrical equipment if PF is gone over 0.996 in leading when provider say that its keep in minimum 0.996lagging

3 Answers   ABB,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5086)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4456)
  • Electrical Engineering Interview Questions Electrical Engineering (16639)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)