Hi everyone,

I'm Lachuu, recently joined automation company as PLC
Engineer. I have certain basic question, I request all big
gurus and seniors to answer these question. Because this
will be very helpful to me as well starters like me.

How to design a control circuit (ex: pick & place - my
current project) Yamaha robot PxYx series controller RCX222,
using 6 cylinder double acting, plc keyence kv p16r 2
expansion unit for input and output each. How to select
panel terminal mcb elcb powersupply.

My main concern in some projects how to select dc power
supply, mcb rcb(I came across dif bt b c d curves, but stil
confusing, pls help me :-(.

I would really appreciate all who are going respond to this
question.


No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

i need some project topics along with circuit diagram in the electrical adnd electronics engg and also give ome website regarding projects.my mail id is thenmozhi2k7@gmail.com .please help me.

0 Answers  


what types battery chargers are there?wanted with details.

3 Answers   SCS,


What is meant by RCCB

3 Answers  


why we did not get shock by touching nuetral of any single phase supply of a electrical equipement?

6 Answers  


I have tow 200 KVA UPS, both are in parallel mode.My question is that, both are running on battery when power fail, if one of them fail (Eg rectifire fails or some other reason), at thet time reverse power will come to faild ups if it comes then it will harm to failed ups or not? if not then how it protects to faied ups????????????????

1 Answers  






when we decide to use soft starter drive or vfd drive in mcc to operate apump?

0 Answers  


What is the average hieght of a electrical tower? what are the factors that are taken into consideration for deciding its hieght other than voltage level?

1 Answers  


why high current produce in case of transformer when turns are internally gets shorted.

3 Answers   TCS,


what is the use of piston rings in the engine used for a generator...........

0 Answers  


Hydro P.P. run @ 600 rpm,8pole, Nucler P.P @ 1500rpm 4 pole , ThermlP.P @ 3000 rpm 2 pole.Why this diffrence??? when we can generate electricity @ 600 rpm then Why we had incresed speed in NPP & TPP???

3 Answers  


what is the principle of operation of synchronous motor and generator? explain in detail.

2 Answers   Maruti Suzuki,


How can you start-up the 40w tube lite with 230v AC/DC without using any choke/Coil?

2 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)