what is 43 & 53 in cement
Answers were Sorted based on User's Feedback
Answer / shakti
It is the grade of the cement i.e,it implies that the
strength of cement achieved after 28 days of curing will be
43mpa & 53mpa respectively.
Is This Answer Correct ? | 59 Yes | 1 No |
Answer / pinakin
Characteristic compressive strength after 28 days
Is This Answer Correct ? | 13 Yes | 2 No |
Answer / n.rajeev
That is grade of cement. like how we speak concrete grade.
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / madhu sudhan reddy
ITS REFER THE MINIMUM COMPRESSIVE STRENGTH OF THE CEMENT AFTER CURING THE 28 DAYS AT NORMAL TEMPERATURE....
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / emdadul haque
The number (43&53) to the specified Characteristic
compressive strength of 150mm size cube at 28 days,
expressed in N/sqmm.
Is This Answer Correct ? | 7 Yes | 7 No |
Answer / munish neb
43 & 53 grade has no relation to its compressive strength. These grade gives the fineness modulus of the cement. More finer cement ,it settle early and have hydration of heat is more that's why 53 grade need more curing than 43 grade. After 28 days, the strength of the all grade cement is same.
Is This Answer Correct ? | 2 Yes | 4 No |
Answer / mitraj
53 grade cement produce more heat of hydration then
43...henc its not good then 43 grade......
Is This Answer Correct ? | 0 Yes | 3 No |
how much distance to provide lap lengths in footings,plinth beams, columns, beams& slabs
How to distinguish that the soil is clay, silt, sand & murrum at site. (just by looking at it with out doing the sieve analysis test??
how to calculate quantity of steel & concrete in stair case
7 Answers Al Fara, Indu Projects, Orbit Corporation, Shree Shakti Enterprises,
what do you know lean concrete
how many kg of gypsum required for 100 sq.ft wall (thk of plaster is 12 mm)
1 Answers Indu Projects, Tata Tiscon,
How to calculate per inch area in a circle?(Dia is 2.17m)
father of soil mechanics
how is the wastage component in structural steel being considered while doing the reconcillation for the fabrication with returning of scrap under 1 meter length
4 Answers LIC, NTPC, Tata Steel Limited,
what is the cost difference of a same structure when it is constructed with brick masonary and when it is constructed with block masonary and concrete as a frame structure????????????????????????
how to find ssm in foundation?
Why silt content not allowed more than 6% for Sand ?
how to calcualate the amount of stone,cement,sand required for 1cum of 450mm thick ruble stond masonary with ratio1:5, please me an answer with dtailed step