Interested to Buy Any Domain ? << Click Here >> for more details...
What is the diff. Between rectangle & parallelogram?
- 10 Answers
- 32826 Views
- I also Faced
- E-Mail Answers
Answer Posted / busireddyravi
In rectangle all the corners are must be angle of 90 degree
and opposite sides and diagonals (Diagonal are mutually
perpendicular to each other) are equal in length , where
as in parallelogram face to face sides are parallel to each
other and diagonal are not equal (not perpendicular to
each other)but it not necessary to meet in right angles at
corners.
| Is This Answer Correct ? | 21 Yes | 7 No |
Post New Answer View All Answers
satart to end steps by step process of building construction...? i want to planning theme accuretly
what post do you prefer to work in this company and why do you think you can serve better in such position?
5. Two long boundary walls run parallel to each other at a center to center distance of 1 meter apart. The width and height of the first wall are 0.30 m and 2.5m respectively. While those of the second are respectively 0.18m and 3.5m. Plot the distribution of vertical stress intensity due to walls on a horizontal plane, 1m below ground level. The walls have negligible depth of foundation and are made of brick masonry (y = 19.2 kN/m cu)
How do you convert wind speed into force?
1.Fe500 and Fe550 having more yield strength than Fe415.But why are we prefering Fe415.? 2. d^2/162 formula for knowing the steel wt/m apply all these three? Thanks.
how statics is different from dynamics
what is high type road and low type roads
What are the uses of layer?
Differentiate orthographic and isometric projections?
HDPE pipe standard bends using for TSE irrigation? is it possible to use 30 degree?
Which is stronger solid steel rod or hollow steel pipe?
sir I got selected in rail vikas nigam limited and they call for interview but i don't what they will ask in interview please guide me if you have any experience
how to control PQI (Project Quality Index)
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
how to find ssm in foundation?
