Answer / dinesh

since %impedance is the per unit value, u can get the short circuit fault current level by,

Ifault = Irated (phase current) / %z..

Similar method if u need fault level MVA....

Answer / k.prakashchandra

% impedance( Say P )= I rated x Z x 100 /V rated. Hence Z =
P x Vr /Ir x 100. Fault current If = Vr /Z .Then If= Ir x100/P

Answer / k.prakashchandra

I think you have to multiply by 100 ,in the above answer as
otherwise the fault current will be less than the rated.

as ac supply is given 2 the transformer why it doesnot depends upon powerfactor????

2 Answers  

---

WHAT IS MEANT BY SHEATH VOLTAGE IN 132Kv cable?

0 Answers   L&T,

---

Whether earthmat designning is done only for sub station or it can be done for multy residential complexes also? What is the size, type & arrangement of the earth grid to be done?

1 Answers  

---

why ac wave is sinusoidal not square or triangular wave what will be reason

1 Answers   ACPL,

---

15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help

0 Answers  

---

IAM GOING TO ERECT THE STREET LIGHT.,, I NEED HOW TO CALCULATE LUX., ILLUMINATION.,AND ALL

1 Answers  

---

Advantage of 11KV ring main system with open point

1 Answers   Alam Group of Companies,

---

what is bus duct and what is differance between bus duct and bus bar

6 Answers  

---

What safety precaution are to be taken for avoiding electric hazards ?

0 Answers  

---

What is reactance, reluctance,capistance, pls give answeer in hinglish and be simply Jo asani we smajh m aa jaye

0 Answers  

---

I am having a DG set.The 415 V from Generator is step up to 460 v and then the same is used for Induction furnace. before Step up, I am connecting LT load to my factory use. When Induction furnace is in service from DG, when i try to start a motor, the generator is tripped.Please tell me the reason.

3 Answers  

---

What should be the dielectric strenght value of transformer oil of 11/0.433KV distribution transformer and 33/11KV tranmission transformer ?

2 Answers  

---