What is the method & formula of Fault level calculation in
power Transformesr.
- 3 Answers
- 5194 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
% impedance( Say P )= I rated x Z x 100 /V rated. Hence Z =
P x Vr /Ir x 100. Fault current If = Vr /Z .Then If= Ir x100/P
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
why different series of vfds (like allenbradley)are used in industry ?
Does the direction of rotation of d.c. Shunt motor would get reversed if the armature current and field current both are reversed?
the winding of Generator and Motor is star or in delta ? and why
Post possible questions for Power Factor Panel FAT / SAT
will there be any problem by recovering slip from single phase induction motors?
Why hydropower stations are preferred solution for meeting peak loads in grids?
Which type of DG need Netral Earthing?
What is the difference between circuit breaker and isolator
why 15 kw motor winding resistance is low then 5 kw motor winding resistance?
Why it need to form a capcitor when it not been in use from three or two year. Plz describe it technically.
during installation time of transformer and alternator which points we have to observed?
what is consequences of neutral and earth connect?
How each of the following losses occur in d.c machines (i) copper (2)core (3) windage (4)friction please help me
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
An ISP is granted a block of addresses starting with 150.80.0.0/16. The ISP wants to distribute these blocks to 2600 customers as follows. a) 200 medium size businesses; each needs 16 addresses b) 400 small businesses; each needs 8 addresses c) 2000 households; each needs 4 addresses Design the subblocks and give the slash notation for each subblock. Find out how many addresses are still available after these allocations.
