What is the method & formula of Fault level calculation in
power Transformesr.
- 3 Answers
- 5193 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
I think you have to multiply by 100 ,in the above answer as
otherwise the fault current will be less than the rated.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the principal of motor?
List the advantages of star-delta starter with induction motor?
What is the current carrying capacity of 35sq.mm flexible cable?
What is reactive power and where it is used.
Give the topology of current amplifier with current shunt feedback?
The windings of a transformer are divided into several coils, because?
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
What are the limitations of Kirchoff's laws?
What is the general system requirement of alternator?
In EHV transmission line a neutral grounding reactor is often placed at neutral point of shunt reactors. What is the recommended protection for this neutral grounding reactor? Should I use a fast closing switch to bypass neutral grounding reactor when this protection operates?
List advantges of active filter over passive filter?
what are the differant std sizes of cable trenches?
What if the difference beween internal and exrteranal LBB?
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
