Answer / u.prabhagaran

10000

A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.

0 Answers   MNC,

---

Please explain for RS 485 & RS 232 communication

1 Answers   Honeywell,

---

Anybody can tell me  how to convert mmHg2o /psi to scfm  please give me formula of conversion

0 Answers   Samsung,

---

What is T4 temperature in compressor?

1 Answers  

---

What is the role of P(Protional), I(Integral) and D (Derivative) in PID Controller?

9 Answers  

---

How to calibration coriolis flow meter?

0 Answers  

---

What information needs for Control Valve "sizing"

1 Answers   Qatar Petroleums,

---

Are Coils of Electromagnetic flowmeter in direct contact with fluid material

4 Answers   TATA,

---

What is eddy current? Describe the operating principle of proximity probe.

0 Answers  

---

What is megering????

2 Answers  

---

What is the difference between HMI and SCADA and MMI

4 Answers  

---

what are the problem's will accure in dcs or plc hadware and what are the solution for it?

2 Answers  

---