Answer / abdul rehman

y = mx + b

where:
y = Output (voltage in this case)
m = Span Adjustment
x = Input
b = zero adjustment (offset)

Why we are using 4-20 mA as Analog signal transmission other than 3 to 19 or 2 to 18 or 6 to 22 like wise ? What is the reason behind using 4 & 20 mA? Can anyone give proper technical reply ?

5 Answers   Air Liquide,

---

WHAT IS D/O D/I AND A/O A/I PLZ EXPLAIN

2 Answers  

---

Explain an adaptive / self-tuning controller’s major draw card.

0 Answers  

---

what is the difference between(Flame proof/Explosion proof)& Fire proof instruments.Both are same or different & if different in which way because the transmitter which have approved ATEX flame proof enclouser but it use PTPE O ring & PTFE Head Gasket,so its (fire safe/fire proof)????????

4 Answers  

---

I have observed in field instrumentation work... I remove the fuse of an analog transmitter then it shows 7.75 kg/sq cm (which is practically wrong value)in DCS and when put the fuse it shows 0 in dcs. Then cheach the field transmitter termination and found moister. clean that and then it shows 1.1 kg/ sq cm which is right value. Please describe the above phenomenon.

1 Answers  

---

send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com

0 Answers   HPCL,

---

defination of radial vibration?

0 Answers   EE Limited, MNC,

---

LADDER LOGIC Can any body state Logic on following condition Instructions to use 1-XIC 2-XIO 3-Output ONLY Program Push 1st button On - 1st lamp should On Then Push 1st button Off - 1st Lamp Should remain on Push 2nd button On - 1st lamp should Off and 2nd lamp should On Then Push 2nd button Off - 2nd Lamp Should remain on.

4 Answers  

---

A motor is taking 15 Amps at no load and 60 Amps at full load. and a valve has to open 10% at full load and 80% at no load. How to draw ladder logic.(PLC).

2 Answers  

---

what is the different between deflection type measurement and null type measurement in RTD?

0 Answers   SHR Solutions,

---

which are types of orifice tap ?

2 Answers  

---

hello this is dhinakar subramanian. how to piping and instrumenation drawings and also how to create the data sheets...

1 Answers  

---