Hi Frnds , If Suppose 1 Pair cable of 1.5 sq mm is used for Transmitter and instead of 1.5 sq mm if i used 0.5 sq mm cable will the resistance change will occur and does it affect our transmitter reading. plz mail ur answer to ntnkamble@gmail.com plz immediately mail ur reply

1 Answers  

---

Difference between guide wave radar & non guide wave radar ?

1 Answers   UPL,

---

in sports(eg,cricket) what is the technique for measurement of speed of the ball thrown by the bowler.

6 Answers   BEL, PSU,

---

what is the use of conrol cable..?

1 Answers  

---

what is all types of analyzer in water production plant?

1 Answers   Marafiq,

---

how u choose thermowell lenght n pnumatic C/v size?

0 Answers  

---

steps for installing orifice plate?

0 Answers   Bhushan Power Steel,

---

We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.

0 Answers   OPaL,

---

what is cold loop? difference between hot and cold loop?

0 Answers   Adani Power,

---

what is the procedure of O2 sensor(ABB) calibration?

0 Answers   Aramco, Samsung,

---

how can you set a zero and span of transmitter?

1 Answers   Rockwell,

---

GIVE BRIEF DESCRIPTION ABOUT "DCS"

2 Answers  

---