The DCS has the following signal type:

Question Posted / jorriz juico

3 Answers
6614 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

The DCS has the following signal type:..

Answer / amit

Analog And Digital type of Signals Are Present

Is This Answer Correct ?

4 Yes

0 No

The DCS has the following signal type:..

Answer / prasad appadi

In instrument signals are their is only two types of signals .
Their is :1.Analog signals.
2.Digital signals.

Is This Answer Correct ?

1 Yes

0 No

The DCS has the following signal type:..

Answer / jorriz juico

a:__________
b:__________
c:__________
d:__________
e:__________

Is This Answer Correct ?

0 Yes

2 No

Post New Answer

More Instrumentation Interview Questions

Describe how to use megger to measure the earth resistance and insulation resistance

0 Answers

how many mmwc are eual to 1kg/sq.cm & can we calculate mmwc into tph?

2 Answers

what is the PC interface and software for connection to ABB logic module “ LM011-CE18RAC “ ( for Programming ) ??

0 Answers

What is transmitter

2 Answers GNFC, QNFS,

What is meant by GAP VOLTAGE, in vibration measurement. Normally how much GAP VOLTAGE is set and state the reason.

3 Answers ADMA OPCO,

If a transmitter is installed 10 m below its tapping point how much pressure exerted if fluid is water?

10 Answers QAFCO,

difference b/w single acting and double acting actuator by using application only?

2 Answers McDermott,

i have D.p. transmitter of range 0 to 2540 mmWC, i want to use this for flow measurement (0 to 500 ltr/hr.) what should i do?

9 Answers

hydrogen purity meter calibrating and commissioning procedure can be explained?

1 Answers

A pressure transmitter with a range of 0-100 bar.The accuracy of the instrument is 1% of upper range value? The pressure indicating transmitter is showing the system pressure is 50 bar. b. When you include the error, what is the minimum possible pressure in our fuel gas system? i. 49.5 bar ii. 49 bar iii. 1 bar iv. 0.5 bar We want to change the filter cartridge. We must depressure the fuel gas system. c. After we depressure the system in preparation for maintenance, the transmitter displays a pressure of +0.1 bar. At this time, what is the possible range of pressures in our fuel system? i. +0.099 to +0.101 bar ii. 0 to +0.2 bar iii. -0.1 to +0.3 bar iv. -0.9 to +1.1 bar

3 Answers

when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?

0 Answers

Turbidity analyzer working principle ?

0 Answers Tata Steel Limited,

For more Instrumentation Interview Questions Click Here