Answer / jagan

y particularly 11kv and not 10.5 or 12kv ,These are standard we made ,our standard distribution is 11,22,33,66,132,220,400,765kv like this,so accordingly we use .The basic depends on formfactor.

Answer / k.prakashchandra

It is a compromise between size of the conductor and
insulation level

When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<

0 Answers   Lupin,

---

What is an iron loss or core loss pi?

0 Answers  

---

What is CBCT ? Why & Where it is used?

14 Answers   BCT,

---

whats was the problem if neutral and earth got 2volt from the ups output

1 Answers  

---

what is the interrelation between voltage current torgue speed and magnetic flux in case of different types of electric motors

0 Answers  

---

how to get 48 V DC I have ... 1. 12 volt power supply board 2. DC power supply ( max. 30 v) 3. 9 volt batteries ( 2 - not chargeble)

2 Answers  

---

in elevator industries , how to calculate the required KVA for the elevator (elevator spec- 40A module , motor of 13.5KW, 20A)

1 Answers   DLF, Tata Steel Limited,

---

What should be the earthing resistance of an industrial substation and also What should be the house hold earthing resistance?

20 Answers   Jindal, Pharma, TAAT, TATA,

---

In 3 phase induction motor 1hp current rating is 1.5 amps constant ? is correct or not ?

4 Answers   TATA,

---

According to IEC60034-14, When the vibration monitoring system required for motor Bearing. above which KW, it is required? and for what type of bearing the vibration probe is provided.

0 Answers  

---

Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?

0 Answers   Accenture,

---

please can i know about total harmonic distortion and how i can calculate it and if anyone can help me to find any program to help me to calculate THD?? please need it

1 Answers  

---