I would like to know that the fault curretn at base load
and at 10% generation will be same? Fault level of BUS
remain same with different generation?
No Answer is Posted For this Question
Be the First to Post Answer
Is it possible to use AC supply insted of DC supply in trip coil operation? if not, why?
what is surge voltage and surge current?
send me all basic electrical question and answers
How to calculate capacitor bank size at a load 800kVA.
can we run all LT motors at 360 volts which are normally rated 415+/-10% voltage rating
do we need NGR panel when the output of the genset is LV but after that it is step up to 22 kv. condition is 12 genset 400v are operating in parallel.
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
What is the principle of Excitation.
which strater used genearalyy???and why???
What will happen if the rotor of an induction motor is fed from a 3 phase supply and the stator short circuited ?
what are the losses of capacitor??
How will you calculate the correct KWH value if your CT is 600/5 and your KWH meter is rated for 100/5
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)