what happens when the supply frequency to the tube light is reduced to 25Hz...

Categories >> Engineering >> Electrical Engineering
Suggest New Category

what happens when the supply frequency to the tube light is
reduced to 25Hz....?

Question Posted / santhosh27ab

5 Answers
8375 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what happens when the supply frequency to the tube light is reduced to 25Hz....?..

Answer / md. obaydur rahman

The tube light is flickering and we can see it with open eye.

Is This Answer Correct ?

18 Yes

0 No

what happens when the supply frequency to the tube light is reduced to 25Hz....?..

Answer / al hasib sheikh wasiu

If the supply of frequency is reduced to 25Hz then light will
flickering slowly which can see easily because of much time
require to flicker the bulb.

Is This Answer Correct ?

4 Yes

0 No

what happens when the supply frequency to the tube light is reduced to 25Hz....?..

Answer / k.prakashchandra

But the inductance(impedance) of the choke is reduced to
nearly 50 % and the filaments of the tube may burn out due
to over current.

Is This Answer Correct ?

4 Yes

0 No

what happens when the supply frequency to the tube light is reduced to 25Hz....?..

Answer / neeraj

tube light
will not glow

Is This Answer Correct ?

4 Yes

3 No

what happens when the supply frequency to the tube light is reduced to 25Hz....?..

Answer / mohandas

The choke is designed to generate a particular amount of high voltage when the starter contact breaks the supply to the choke. This high voltage discharges through the filament and in turn ionises the gas in the fluorescent tube. However when you reduce the frequency to 25Hz the high voltage produced by the choke will reduce considerably which may be insufficient to ionise the gas and the tube may not glow.
However if the frequency is reduced when the tube is already on and working the tube will continue to glow but with less luminosity.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?

0 Answers

Advantage of LT panel vs HT panel

0 Answers

does the power factor of an induction motor improve upon used in parallel with a synchronous condenser , used commonly to provide a leading kva ?

1 Answers

A single line diagram(SLD) and a purchase order of a 11/66kV switchyard of a power plant was given. In the SLD, only one lightning arrestor(LA) was shown, but the purchase order had need of 3 LAs. Is this correct, if yes, why?

2 Answers

What is the safe limit of voltage between earth and neutral in india.

2 Answers Incepta Pharmaceuticals,

WHY CURRENT DECREASES WHEN VOLTAGE IS INCREASED IN A CURRENT TRANSFORMER ?

5 Answers Sterling Wilson,

How does CT can measure the high value DC current?

4 Answers

WHAT IS REACTIVE POWER?

2 Answers

can any one tell in easy method for circulating current ??

0 Answers Quest,

What is EPBX????