Answer / carl_ellis

Rotating the electronics housing screw loosens or tightens
the screw that holds the housing in place in relation to the
pressure body.

Rotating the electronics housing (for access to the screw
covers or to orient the indicator display) with respect to
the housing body has to be done with care to avoid twisting,
crimping, bending, breaking, stretching or stressing the
wiring/cables that connect the sensor(s) elements in the
pressure body to the electronics in the transmitter head.

Most transmitters allow a +/- 180 degree rotation from a
position with the length of the head in axial alignment
with the bore of the pressure ports.

Carl Ellis
Measure First

what is diff between the centrifugal and reciprocating

2 Answers  

---

Describe the concept of Gain Scheduling, as currently found as an option in some controllers.

1 Answers  

---

why cant we use mV instead of mA?

12 Answers   ABB, Power Grid, Qatar Gas, USW, Visa Steel,

---

What is DDC-MIS?

3 Answers  

---

What is the difference between a PLC (Programmable logic controller) and DCS (distributed control system)?

7 Answers  

---

Draw block digram for well head from well to shipping pump?

0 Answers  

---

suppose in dcs range of a flow transmitter is 10t/hr what is dp for 50% in 2500mmwc

6 Answers   Chevron,

---

how to install the Ph and Conductivity analyser? is there are any procedures which has to be maintained.

2 Answers  

---

Which are all the commonly used Bordon tubes in the pressure gauges. Do any one use ASTM A 312 tubes for this purpose?

0 Answers  

---

how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.

0 Answers  

---

How to find out turn down ratio of Pressure transmitter?

1 Answers  

---

what are procedure of sox-nox calibration

0 Answers   TATA,

---