at which voltage level arcing ground is occurs ??????????


No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

how can we find a burden of potential transformer? what does it effects? how can we calculate rated load of it?

4 Answers   Areva, KPTCL,


my question is that....few days ago i had installed a three phase motor starter for an electric saw.the motor will run and make the hydraulic pressure which will be goes to pressure cylender by up and down lever.two number of limitswitches are also installed on cylinder for safety of motor.now when the arm of cylinder reaches to the upper or lower limit it will cut the motor's line.and motor will be stop.now wana know that what will i do that motor runs continue after the limitswitch cut it down but it shold not be made any pressure.pls answer me in brief.

3 Answers  


Why only 1ph,2ph,3ph supplies are universally used?? Why not 4ph or 5ph??

4 Answers  


Why the transmission lines are in 11kV, 22kV, 33kv, and why not 10kV,20kV, 30kV?

2 Answers   Bhel,


What happen Grid EARTH plat got cut.

0 Answers   Zuari,






what percentage of marks in B-TECH is needed for section engineering exam

1 Answers   RRB,


choose the non-switch device (A) transformer (B) diode (C) transistor (D) IC

3 Answers  


what is the exact direction of current? as we know current travels from higher potential to lower potential,so if we take battery +ve to -ve implies current direction is from positive terminal to negative terminal.,whereas electrons flow from negative to positive as they are attracted by positive ions.current will be the plow of charge but not flow of positive ions.please clarify my doubt friends.

2 Answers  


Why the rotor winding is short circuited of induction motor

1 Answers  


advantages of vvvf drives over non vvvf drives for EOT cranes

2 Answers   HEC,


Why alternators are rated in KVA?

12 Answers  


Is the inductance parameter of transmission line affected by taking the earth into consideration?is the same true for capacitance? Justify the answer.

1 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4452)
  • Electrical Engineering Interview Questions Electrical Engineering (16636)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)