Answer / raafat

it depends on the value of power expending by the materials
as resistor in device that is connected to the battery!!

Answer / vijayakumar(kseb, pallam)

Questions is incomplete. Current drain depen on the load
connected to that cell. THANK U FOR ASK ME.....

Answer / sarkars

(550mA x 2 min)/60 = 18.33mA

Answer / prajeesh

Current drain depends up on the load
connected to that cell and mode of connection(if parallel or seiries) and Ampere Hour of the cell....

Answer / venkates001

Thanks. my Circuit current consumption is 200mA which is
connected series to the battery 1.4V (675 size) and rated
capacity is 550 mAH

Answer / raafat

good good now

rated capacity current/the time = drain current

550 / (2 /3600)= (550*2)/3600= 0.3055 mA

regards

Answer / venkates001

Thanks. for example i have a circuit has 4 components which
is draws current(1 A) from the battery.Help me to calculate
the current drain over a time using DAQ card (any
instruments)

What is the min and max ohmic value for earthing?

15 Answers   NewTek, Wipro,

Is there any relation between transformer capacity and its bdv?

1 Answers  

why we permissive overreach in distance protection.where it is applicable to use in long r short lines

0 Answers  

thyristor controlled APFC panel design parameter?

0 Answers  

what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks

0 Answers  

what is the difference between the megger and multimeter operation ?

3 Answers  

I have two AC generators, the first rated 2680KVA for 380V/4345A/pf:0.7 and the second rated 3461KVA for 5500V/363A/pf:0.8. I want to parallel the two generator to a bus. The second generator passes through a transformer to down the voltage to 380V and a part of its power goes to another bus so that it's only a part of the total power of the second generator taht goes to the considered bus. I have two Basler DECS100 AVR regulator. How can I make the synchronization ? What others equipments must have ?

1 Answers   CST,

what is the control circuit for operating the clean room air shower

0 Answers   L&T,

Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job

0 Answers   Bhel,

IDMT relay are mostly used for protection against..??? 1)Earth Fault 2)Inter turn fault 3)Overloading 4)None of the above

1 Answers   Indian Railways,

When charging a 20 MVA , 33kV/6.6kV transformer through regulated (0-6.6 kV or 0-33 kV) source on no load , what will be the maximum current drawn by transformer from source and what sould be the source capacity.

5 Answers   TATA,

as ac supply is given 2 the transformer why it doesnot depends upon powerfactor????

2 Answers