Answer / gopi ramesh

It is a small portion of pipeline which having two flange ends and basically used for fitting any external connection to the pipe stream.

Answer / arjun

when a particular pipe structure (need not to be straight,
may include tees elbows etc...) is repeated in a plant
piping , the repeating structure is shop_welded and
assembled at plant during erection. the same is known as spool.

Can anyone help me to find out the book where all chemical engineer problem is solved.

3 Answers  

---

REACTION ENGINEERING - EXAMPLE 13.1 : In a furnace, 2 chemical reactions are happening - 1 mole of solid carbon reacts with 1 mole of oxygen gas to generate 1 mole of carbon dioxide gas; 1 mole of solid carbon reacts with 0.5 mole of oxygen gas to generate 1 mole of carbon monoxide gas. In a given process, 100 kmol of carbon is burned in a furnace. (a) Calculate the theoretical oxygen gas needed by assuming that all the carbon is burned completely to carbon dioxide gas. (b) Calculate the theoretical air needed by assuming that all the carbon is burned completely to carbon dioxide gas and there is only 21 % of oxygen gas. (c) Determine the amount of air required (in kmol) if 50 % excess oxygen gas must be satisfied for (a) and (b). (d) It has latter been found that 20 % of the carbon undergoes incomplete combustion resulting to carbon monoxide gas production. The rest of the carbon undergoes complete combustion. Calculate the total oxygen gas required stoichiometrically based on the actual process.

1 Answers  

---

Explain some common piping materials used to transport slurries?

0 Answers  

---

What fluid first to be lined up in a heat exchanger whether hot or liquid?why?

2 Answers   TCL,

---

Question 69 - A well delivers 225 US-gallons per minute of water to a chemical plant during normal system operation. (a) Calculate its flowrate in the unit of mega US-gallon per day or MGD. (b) The following formula is written next to the chlorine feed point : (chlorine feed rate, lb / day) = (flowrate, MGD) X (dose, mg / L) x (8.34). If this formula is correct, then what should the chlorine feed rate to be in pounds per day (lb / day) if the desired dose is 2 mg / L. (c) Prove by calculations that the constant 8.34 in the formula next to the chlorine feed point is correct. Let 1 US-gallon = 3.78541 L and 1 mg = 0.0000022046 pound.

1 Answers  

---

Are there flow velocity restrictions to avoid static charge build up in pipelines?

0 Answers  

---

What is the process of Scrubber ?

3 Answers  

---

A concentric, counter-current heat exchanger is used to cool lubricating oil. Water is used as the coolant. The mass flow rate of oil into the heat exchanger is 0.1 kg / s = FO. For oil, the inlet temperature TIO = 100 degree Celsius and the outlet temperature TOO = 55 degree Celsius. For water, the inlet temperature TIW = 35 degree Celsius and the outlet temperature TOW = 42 degree Celsius. What is the mass flow rate of water in kg / s, FW needed to maintain these operating conditions? Constant for heat capacity of oil is CO = 2131 J /(kg K) and for water is CW = 4178 J /(kg K). Use the equation (FO)(CO)(TIO – TOO) = (FW)(CW)(TOW – TIW).

1 Answers  

---

Specific Heat of Bagasse at 50% moisture, 40% moisture and 25% moisture?

0 Answers  

---

What is happening when paint dries?

0 Answers  

---

What is critical radius of insulation?

0 Answers  

---

Why catalyst is charging in chemical reaction as high pressurized pellet of tablet?

2 Answers  

---