what are adantages of OC and SC test over the load test?
Answers were Sorted based on User's Feedback
Answer / karthik_elec
we can calculate the performence and efficiency of machines
with out applying the loads.
Is This Answer Correct ? | 18 Yes | 2 No |
Answer / raju
By OC test gives Core + Hysteresis loses and SC test gives
Total Copper losses.
Is This Answer Correct ? | 12 Yes | 1 No |
Answer / jagan
oc test used to calculate core loss & sc to calculate
copper loss its helps to find efficiency
Is This Answer Correct ? | 8 Yes | 3 No |
Answer / surendra
directly loading is avoided such that our equipment can be
tested most economically
Is This Answer Correct ? | 8 Yes | 10 No |
what is cathodic protaction?
hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"
We are installing a 1.6 MVA transformer at our crusher plant and the feeder of HPSEBL is 2 km away at substaion . and a VCB is installed in the substaion which is 2 km away from transformer so we need another VCB near the transformer.
what is the best transformer oil breakdown voltage?
why we use 20 KV, 10KA LA on 22 KV Line
sir what is the minimum IR value of 11 KV alternator?
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet
Define ohm’s law for a.c (alternating current)?
does magnetic interlocking take place in an induction motor ?
In oil transformer which oil is used & what should be the insulation resistance & heating capacity.
please write motor, transformer, Generator setting, fault level calculation of Tr.etc
why the secondary current transformer cannot left open