Answer / harsh shah

It is a isolator where the three pole phases are aligned
digonally ie. all the pole phases are connected one behind
another so that the jumpering can be done on the bus bar

Answer / nitin

It is the isolater which is operate all three pole one by one and it is use where to be maintained the clearence between the phase.

Answer / dinesh kumar yadav

Tendam isolatar is a type of iso latar in which three phase are alinged to each other in a digonaly when the foult is accure in any eqipment in sub station the it oprated to cuts the suppy of the bus isolatar is known as tendam isolatar.

Answer / k.prakashchandra

In continuation to my reply,I wish to add that the
word 'tandem' as a noun, means a bicycle for two
riders ,one sitting behind another.As adverb means, one
behind another

Answer / k.prakashchandra

It is a double break isolator which isolates both sides and
used in all stations

it is clear that volts equal to the current as per ohms law. is it appliable to the AC power or only for DC. if it is appliacable to AC in transformers when voltage increases the voltage decreases ????? why??????????????

13 Answers   Bhel,

explain remenance . differentiate high remenance type ct & low remenance type ct

0 Answers   Coca Cola,

WHAT IS START TO INDUCTION MOTER IN STAR TO DELTA OF >5HP ?

0 Answers  

transformers? power factor? machiences?

3 Answers  

IN star -delta motors normally first operated in star mode {absulated given (r-y-b) phases after one miute change in delta mode in this case i am change phase sequience for example R -PHASE TO CHANGE Y-PHASE ;Y-PHASE TO CHANGE R-PHASE SO THIS TIME MOTOR WILL HAPPEN RUNNIG MODE EIGHTER(OR) STOP MODE(TRIP MODE)

6 Answers   MacLellan,

why it is necessary to maintain frequency constant in a power grid ?

1 Answers   NTPC,

Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?

0 Answers  

what is idmt relay

1 Answers  

What is battery Amphere-hour? How the battery back up time period is calculated?

2 Answers  

What safety precaution are to be taken for avoiding electric hazards ?

0 Answers  

Why is shaft current insulation required on large motors & when should it be checked i.e. before or after assembly?

2 Answers   Aramco,

What is actual name of Transformer oil.

6 Answers