what happens in the primary side of the transformer if
transformer is short circuited first and increasing the
resistance of the short circuit gradually?
Answers were Sorted based on User's Feedback
Answer / siva
Short cct here means short ccting the secondary. at that
time, transforemr will deliver it's short cct capacity of
current, normally 1/Z in p.u. terms. if the resistance
increase the current in secondary will reduce but the
effect of resistance is negligible considering the
secondary winding inductance!
| Is This Answer Correct ? | 4 Yes | 0 No |
Answer / k.prakashchandra
Short circuiting primary means short circuiting the incoming
supply itself
| Is This Answer Correct ? | 3 Yes | 3 No |
Answer / vamsi
when the primary of t/f is open then it induses some flux,lly
when secondary is also open then both the fluxes combines ,it
generates heat ,so it tends to many losses.so if secondary is
shorted then secondary prevents from entering ,it just stops
it so more flux is not generated,which will protect it from
losses,performance is also increased.
| Is This Answer Correct ? | 0 Yes | 10 No |
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
What are the steps for Testing of 6.6KV HT Panels?
how steam converted into electricity in power plant
What is the Difference Between the SCADA & PLC ? Both it also control and Supervise Then what Special in Scada & PLC?
When will you multiply and devide with derating factors to the actual value while sizing the cable?
Hi,I am working in abroad for more than 3 years in a company operating with 11kv and 6.4 MW power. I need c licence in India,can I? some other says only i can get if i work for 2 years in india only! anybody kindly clarify by doubt.Thanks
Short circuit voltage of a transformer mainly depend on A ohmic resistance of primary B ohmic resistance of secondary C magnitude of leakage flux D cross sectional area of core
how encoder works?
how to design the heater in temperature control unit to heat 50KL of water?
what is the equation of insulating resistance of motor???
A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE
Impedance relay is directional relay or non directional relay?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)