Answer / leo11_taxalian

Transmission line parameters are resistance, capacitance,
inductance and conductance.
Transmission line constants are A,B,C,and D, which are
based upon the standard equation Vs=AVr+BIr and Is= CVr+DIr
and constants are found solving the networksusing the
kirchoff's current and voltage law.

acsr dog conductor specification

1 Answers  

---

Off-circuit Tap changers in distribution transformer required

1 Answers  

---

what's mean by Transient stability analysis?

1 Answers  

---

what is the difference between MCCB and SFU in terms of their application?

2 Answers   Secure Meters, Tata Teleservices,

---

Why we did not feel electric shock in electric train?

1 Answers   NTPC,

---

current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer

0 Answers  

---

why occ curve is not tracing back when we are bringing rheostat back in reverse direction?

0 Answers  

---

IF 3 NOS.OF HEATERS,3KW CAPACITY EACH,1 NO.HEATER CONNECTED IN R PHASE,1 IN Y PHASE AND 1 IN B PHASE.THEIR END POINTS CONNECTED IN STAR.IF I CONNECT THIS STAR POINT TO NEUTRAL OR DO NOT CONNECT TO NEUTRAL.WHAT WILL THE DIFFERENCE.

3 Answers  

---

what the purpose of protection signaling equipment in substation?

2 Answers  

---

what is the difference betn earthed and unearthed cables which is commanly used why?

2 Answers   Bhel, Power Grid,

---

Why we are putting off the APFC(automatic power factor control) panel while the generator is running?

4 Answers   National Steel,

---

how many units (kwh) are there if in one MW?

5 Answers  

---