Answer / arshad.dullah

440/230v 3 phase 4 wire

in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com

0 Answers  

---

Why we use neutral cable just half from phase cable.Tell me briefly,please.

4 Answers  

---

what is meant by mimic diagram ?where it is used ?plz explain briefly

2 Answers  

---

what is the difference betwteen overcurrent and short circuit fault?

3 Answers  

---

it is difficult to interrupt a capacitive current because (a)it has a leading power factor (b)current magnitude is very small (c)the restriking voltage can be high (d)stored energy in the capacitor is high

2 Answers   DGVCL Dakshin Gujarat Vij Company, MGVCL, UGVCL Uttar Gujarat Vij Company Ltd,

---

---

Re: can you give main difference between ELCB 2pole And RCCB 2pole? And how this devices operated?

4 Answers  

---

bit confused - am i correct in thinking that to determine line to line voltage in a star config 110v 3 phase 4 wire distribution system i would use a voltmeter? I have a circuit configured as an unbalanced load, consisting of three incandescent lamps (1x40w, 1x60w, 1x100w - all 110v rated)connected in a star configuration to a 110v 3 phase 4 wire distribution system. I want to find out what types of meters i would use to obtain: a) each line to line voltage b) the line to neutral voltage across each load c) current flowing in each line and load d) current flowing in the neutral conductor e) power supplied to the loads im assuming i would be using ammeters in series along each line and voltmeters in parallel across each line to neutral? Also how could i predict these meter readings before taking them and with which formulae? Any help would be greatly appreciated A.

1 Answers  

---

what is high voltage in india?

11 Answers   Essar,

---

what is the reason of battery voltage is 12v maintain?please answer me.mail-psrinivasan20@yahoo.com

1 Answers   CTS,

---

difference between servo motor and synchronous motor

0 Answers   Hitachi,

---

A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N

0 Answers  

---

what is the aircraft voltage and frequency standard ?

1 Answers   Jet Airways,

---