Answer / aer

The Lead Acid battery is made up of plates, lead, and lead
oxide (various other elements are used to change density,
hardness, porosity, etc.) with a 35% sulfuric acid and 65%
water solution. This solution is called electrolyte, which
causes a chemical reaction that produce electrons. When you
test a battery with a hydrometer, you are measuring the
amount of sulfuric acid in the electrolyte. If your reading
is low, that means the chemistry that makes electrons is
lacking. So where did the sulfur go? It is resting on the
battery plates and when you recharge the battery, the
sulfur returns to the electrolyte.
Safety
Battery types, Deep Cycle and Starting
Wet Cell, Gel-Cell and Absorbed Glass Mat (AGM)
CCA, CA, AH and RC; what's that all about?
Battery Maintenance
Battery Testing
Selecting and Buying a New Battery
Battery Life and Performance
Battery Charging
Battery Do's
Battery Don'ts

1. We must think safety when we are working around and with
batteries. Remove all jewelry. After all you don't want to
melt your watchband while you are wearing the watch. The
hydrogen gas that batteries make when charging is very
explosive. We have seen several instances of batteries
blowing up and drenching everything in sulfuric acid. That
is no fun, and would have been a good time to use those
safety goggles that are hanging on the wall. Heck, just
break out your disco outfit. Polyester is not affected by
Sulfuric Acid, but anything with cotton will be eaten up.
If you do not feel the need to make a fashion statement
just wear junk clothes, after all Polyester is still out of
style. When doing electrical work on vehicles it is best to
disconnect the ground cable. Just remember you are messing
with corrosive acid, explosive gases and 100's amps of
electrical current.

How to calculate the size of the conductor for particular load

9 Answers   Eskom, HCL,

---

1600kva capacity Transformers how the bucholz relay,Oil temperature,winding,surge relay relays setting are to be done

0 Answers  

---

In a company the lines carrying 33KV but the load is below 10000Volts so we know that <11KV we can put 11KV lines but the lines are 33KV,..so how we can step down the voltage to 11KV with out erecting a substation

1 Answers  

---

What is advantages of ungrounded neutral?

2 Answers  

---

what are the protections in 132 kv class electrical systems.....? hw u define that in elctrical terms..? . . .pls answr

2 Answers   ABB,

---

WHY THE RATINGS OF THE TRANSFORMER IS 33KV WHY NOT OTHER???

0 Answers   Lanco,

---

What is the Difference Between resistance and resistivity?

2 Answers   Sun Pharma,

---

how moving coil indicator works?

1 Answers  

---

how steam converted into electricity in power plant

4 Answers  

---

why we r used APFC Panel in industrial area.when P.F. low then wat will be the effect in our system?

10 Answers   ABB, Georgio Rocks, Piramal Healthcare, Zenith Engineering Corporation,

---

which power plant has high load factor?

12 Answers   APTransco,

---

HOW TO SIZE THE TRANSFORMER OR WHAT ARE THE STEPS INVOLVED IN FINDING THE SIZE OF THE TRANSFORMER FOR GIVEN LOAD SAY 2000KW ?

1 Answers  

---